1.1 本规范规定了适用于制冷和空调产品或其他热交换器的直管段或盘管焊接内部增强铜管的要求。 1.2 单位- 以英寸-磅为单位的数值应视为标准值。括号中给出的值是到国际单位制的数学转换，仅供参考，不被视为标准值。 1.3 产品应由以下铜片制成。除非另有规定，否则可提供以下铜管: 铜UNS编号。 金属类型 C10200 无氧，无残留脱氧剂 C12200 磷化、高残留磷（DHP） 1.4 以下内容与中所述的试验方法有关 18.5 符合本规范的要求。 本标准并非旨在解决与其使用相关的所有安全问题（如有）。 本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管要求的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification establishes the requirements for welded, internally enhanced copper tube, in straight lengths or coils, suitable for use in refrigeration and air conditioning products or other heat exchangers. 1.2 Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 The product shall be produced of the following coppers. Unless otherwise specified, tubes made from any one of these coppers may be supplied: Copper UNS No. Type of Metal C10200 Oxygen-free without residual deoxidants C12200 Phosphorized, high residual phosphorus (DHP) 1.4 The following pertains to the test method described in 18.5 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.