1.1 本试验方法涵盖了沥青铺路混合料中使用的矿物填料的筛分分析。 1.2 以国际单位制或英寸-磅单位表示的值应单独视为标准值。每个系统中所述的值可能不是完全等效的；因此，每个系统都应独立使用。将两个系统的值结合起来可能会导致不符合标准。 注1: 关于筛网，根据规范 E11 “以国际单位制表示的值应被视为钢丝网开口尺寸和钢丝网中使用的钢丝直径的标准值。”当参考筛网尺寸时，备用英寸- 英镑名称仅供参考，并附在括号中。 1.3 本标准的文本引用了提供解释性材料的注释和脚注。这些注释和脚注（不包括表格和图表中的注释和脚注）不应被视为本标准的要求。 1.4 本标准并不旨在解决与其使用相关的所有安全问题（如果有的话）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。 =====意义和用途====== 4.1 该方法用于确定矿物填料是否符合规范的级配要求 D242/D242M .

1.1 This test method covers the sieve analysis of mineral fillers used in asphalt paving mixtures. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. Note 1: Regarding sieves, per Specification E11 , “the values stated in SI units shall be considered standard for the dimensions of the wire cloth openings and the diameter of the wires used in the wire cloth.” When sieve mesh sizes are referenced, the alternate inch-pound designations are provided for information purposes and enclosed in parentheses. 1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 The method is used to determine compliance of mineral fillers with the grading requirements of Specification D242/D242M .