1.1本规程描述了当需要作为其他试验方法的准备步骤时，安全气囊织物的加速老化程序。 1.1.1在第节中，本规程列出了与安全气囊设计和制造有关的四种加速老化方法。具体如下: 描述 部分 循环老化 8.4 热老化 8.5 湿度老化 8.6 臭氧老化 8.7 1.2当需要对老化织物试样进行后续物理性能测试时，本规程可与其他ASTM测试方法结合使用。 1.3除本实施规程中规定的程序和仪器外，买方和供应商可通过协议使用，具体偏离报告中承认的标准实施规程。 1.4以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值不是精确的等价物；因此，每个系统必须相互独立使用。 1.5 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。

1.1 This practice describes the procedures for the accelerated aging of inflatable restraint fabrics when required as a preparatory step for other test methods. 1.1.1 In Section, this practice lists four methods for conducting accelerated aging that are of concern to the design and manufacture of inflatable restraints. They are as follows: Description Section Cycle aging 8.4 Heat aging 8.5 Humidity aging 8.6 Ozone aging 8.7 1.2 This practice may be used in conjunction with other ASTM test methods when subsequent tests of physical properties are required of aged fabric specimens. 1.3 Procedures and apparatus other than those stated in this practice may be used by agreement between the purchaser and the supplier with the specific deviations from the standard practice acknowledged in the report. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.