1.1 本规程涵盖了获得高质量热浸镀锌涂层应采取的预防措施。 1.2 如果特定产品的经验表明放松了任何规定，则双方可接受的变更应由制造商和买方达成协议。 1.3 单位- 本规程适用于以英寸-磅为单位的订单（如 第385页 )或SI单位（如 385米 ). 英寸-磅单位和国际单位制不一定完全等同。在本规范文本中，如适用，SI单位显示在括号中。每个系统应独立使用，不得以任何方式组合数值。 1.4 本标准并不旨在解决与其使用相关的所有安全问题（如有）。 本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《国际标准、指南和建议制定原则决定》中确立的国际公认标准化原则制定的。

1.1 This practice covers the precautions that should be taken to obtain high-quality hot-dip galvanized coatings. 1.2 Where experience on a specific product indicates a relaxing of any provision, the mutually acceptable change shall be a matter for agreement between the manufacturer and purchaser. 1.3 Units— This practice is applicable to orders in either inch-pound units (as A385 ) or in SI units (as A385M ). Inch-pound units and SI units are not necessarily exact equivalents. Within the text of this specification and where appropriate, SI units are shown in brackets. Each system shall be used independently of the other without combining values in any way. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.