1.1 本试验方法旨在作为一种混合试验，用于识别或分类慢凝、SS或CSS型乳化沥青。 1.2 以国际单位表示的值应视为标准值。本标准不包括其他计量单位。 1.3 本标准的文本引用了提供解释材料的注释和脚注。这些注释和脚注（不包括表和图中的注释）不应视为本标准的要求。 1.4 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 =====意义和用途====== 3.1 该试验方法的结果表明，慢凝乳化沥青与细碎、高表面积材料（高早期强度、III型硅酸盐水泥）混合而不破坏乳化沥青的能力。 注1: 本标准产生的结果质量取决于执行程序的人员的能力以及所用设备的能力、校准和维护。 符合规范标准的机构 第3666页 通常认为能够胜任和客观的测试、取样、检验等。本标准的用户应注意遵守规范 第3666页 单独使用并不能完全确保可靠的结果。可靠的结果取决于许多因素；遵循规范的建议 第3666页 或一些类似的可接受的指南提供了评估和控制这些因素中的一些因素的方法。

1.1 This test method is intended to be a mixing test used to identify or classify a slow-setting, SS or CSS, type of emulsified asphalt. 1.2 The values stated in SI units are to be regarded as standard. No other units of measure are included in this standard. 1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements for the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 3.1 The result of this test method indicates the ability of a slow-setting emulsified asphalt to mix with a finely divided, high-surface-area material (high early strength, Type III portland cement) without breaking the emulsified asphalt. Note 1: The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.