1.1 本规范涵盖了用于化粪池污水处理/滞留的钢筋混凝土水箱之间连接的弹性连接器的最低性能和材料要求，包括规范中引用的那些 C913 和 C1227 . 1.1.1 这些连接器旨在消除管道和储罐之间的泄漏。 1.2 以SI单位或英寸-磅单位表示的值应单独视为标准值。每个系统中陈述的值可能不完全等同；因此，每个系统应独立使用。合并两个系统的值可能导致不符合标准。 附注1: 本规范仅涵盖弹性连接的设计、材料和性能。本规范涵盖的连接足以承受高达5 psi的静水压力【11。5 ft]根据第节测试时无泄漏 7 已安装系统的渗透或渗出量取决于许多因素，而不是储罐和管道之间的连接器，允许的量必须由其他规范和已安装管道和系统的适当测试涵盖。 1.3 以下注意事项仅适用于试验方法部分，章节 7 ，本说明书的。 本标准并不旨在解决与其使用相关的所有安全性问题（如果有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践并确定法规限制的适用性。 1.4 本国际标准是根据国际公认的标准化原则制定的，该原则载于国际标准、指南和建议的制定原则世界贸易组织技术性贸易壁垒委员会。

1.1 This specification covers the minimum performance and material requirements for resilient connectors used for connections between reinforced concrete tanks used for septic effluent treatment/detention, including those referenced in Specifications C913 and C1227 . 1.1.1 These connectors are designed to eliminate leakage between the pipe(s) and tank. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Note 1: This specification covers the design, material, and performance of the resilient connection only. Connections covered by this specification are adequate for hydrostatic pressures up to 5 psi [11.5 ft] without leakage when tested in accordance with Section 7 . Infiltration or exfiltration quantities for an installed system are dependent upon many factors other than the connectors between tanks and pipes, and allowable quantities must be covered by other specifications and suitable testing of the installed pipe and system. 1.3 The following precautionary caveat pertains only to the test methods portion, Section 7 , of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.