1.1 本指南涵盖了适用于将回转窑生产的膨胀页岩、粘土或板岩（ESCS）材料指定为矿物改良剂的材料特性、物理要求和取样。 1.2 表层土中存在适当的营养和pH值是植物健康生长所必需的。然而，本指南并未涵盖营养素的测定及其可用性。 2. 注1: 表层土的养分含量很重要，通常评估的化学物质为氮、磷和钾。营养不足可以通过使用肥料来纠正。应检查过量可溶盐的可取性。土壤的酸碱度也很重要。过量的酸度可以通过施用石灰粉来纠正。过量碱度可通过施用硫或其他合适的酸化化合物来纠正。在考虑粒径分布时，除降低pH值外，后一项也可被视为骨料。 1.3 单位- 以国际单位制表示的数值应视为标准值。国际单位制后括号中给出的值仅供参考，不被视为标准值。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本指南提供了有组织的信息收集或一系列选项，并不推荐具体的行动方案。本文件不能取代教育或经验，应与专业判断一起使用。并非本指南的所有方面都适用于所有情况。本ASTM标准不代表或取代必须根据其判断给定专业服务的充分性的谨慎标准，也不应在不考虑项目的许多独特方面的情况下应用本文件。 本文件标题中的“标准”一词仅表示该文件已通过ASTM共识程序获得批准。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 4.1 当物理评估土壤时，相对于其支持植物生长（主要是草）的适宜性，必须进行测试，以确定固体物质（有机和无机）兼容性的存在和数量，该兼容性可以确定潜在的空隙含量和持水能力，最后是有害物质。 4.2 规范中给出了合适表土的典型一般土壤含量范围 D5268 . 然而，应当认识到，在某些地理区域，与参考表中的值相一致是困难的。在这种情况下，需要制定当地可接受的规范。 注2: 本标准产生的结果的质量取决于执行该标准的人员的能力，以及所用设备和设施的适用性。符合实践标准的机构 D3740 通常认为能够胜任和客观的测试/采样/检查/等。本标准的用户应注意遵守惯例 D3740 本身并不能保证可靠的结果。可靠的结果取决于许多因素；实践 D3740 提供了一种评估其中一些因素的方法。

1.1 This guide covers the material characteristics, physical requirements, and sampling appropriate for the designation of the rotary kiln produced expanded shale, clay or slate (ESCS) material as a mineral amendment. 1.2 The presence in the topsoil of the proper nutrient and pH level is necessary for healthy plant growth. This guide does not, however, cover a determination of the nutrients, nor their availability. 2 Note 1: The nutrient content of topsoil is important and the chemicals usually evaluated are nitrogen, phosphate, and potassium. Nutrient deficiencies may be corrected by using fertilizers. Excess soluble salts should be examined as to their desirability. The acidity or alkalinity of the soil is also important. Excess acidity may be corrected by the application of lime dust. Excess alkalinity may be corrected by the application of sulfur or other suitable acidifying compounds. The latter item, in addition to lowering pH, also could be considered as an aggregate when considering the particle size distribution. 1.3 Units— The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This guide offers an organized collection of information or a series of options and does not recommend a specific course of action. This document cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of this guide may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project's many unique aspects. The word “Standard” in the title of this document means only that the document has been approved through the ASTM consensus process. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 When physically evaluating a soil, relative to its suitability to support plant growth (primarily grasses), tests must be performed to determine the presence and amount of solid matter (organic and inorganic) compatibility that can determine potential air-void content and water-holding ability, and finally, deleterious materials. 4.2 Typical general ranges of soil content for suitable topsoils are presented in Specification D5268 . It should be recognized, however, that in some geographic regions, concurrence with the values in the referenced table would be difficult. In such situations, locally acceptable specifications need to be developed. Note 2: The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D3740 are generally considered capable of competent and objective testing/sampling/inspection/ and the like. Users of this standard are cautioned that compliance with Practice D3740 does not in itself assure reliable results. Reliable results depend on many factors; Practice D3740 provides a means of evaluating some of those factors.