1.1 本规范涵盖高温应用的沉淀硬化螺栓材料（UNS N07718）和螺栓组件。见规范 A962/A962M 对于“螺栓连接”的定义 1.2 以下引用的一般要求对于本规范的应用是必不可少的:规范 A962/A962M . 1.3 补充要求由买方选择使用。补充要求仅在采购订单或合同中单独规定时适用。 1.4 本规范以英寸-磅和国际单位制表示。但是，除非采购订单或合同规定了适用的M名称（国际单位制），否则英寸-磅单位应适用。 1.5 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。在文本中，国际单位显示在括号中。每个系统中规定的值可能不是精确的等效值；因此，每个系统应相互独立使用。 将两个系统的值合并可能会导致不符合标准。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers precipitation hardening bolting material (UNS N07718) and bolting components for high temperature service. See Specification A962/A962M for the definition of “bolting.” 1.2 The following referenced general requirements are indispensable for application of this specification: Specification A962/A962M . 1.3 Supplementary requirements are provided for use at the option of the purchaser. The supplementary requirements only apply when specified individually in the purchase order or contract. 1.4 This specification is expressed in both inch-pound and in SI units. However, unless the purchase order or contract specifies the applicable M designation (SI units), the inch-pound units shall apply. 1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.