首页 馆藏资源 舆情信息 标准服务 科研活动 关于我们
现行 ASTM D6225/D6225M-98(2020)
到馆提醒
收藏跟踪
购买正版
Standard Test Method for Granule Cover of Mineral-Surfaced Roofing 矿物表层屋面颗粒盖标准试验方法
发布日期: 2020-05-01
1.1 本试验方法包括测定矿物表面屋顶板上颗粒的遮盖力。该试验主要在进行磨损试验后使用,以确定因磨损试验而暴露的沥青化合物部分。 1.2 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值可能不是精确的等效值;因此,每个系统应相互独立使用。将两个系统的值合并可能会导致不符合标准。 1.3 本标准并非旨在解决与其使用相关的所有安全问题(如有)。本标准的用户有责任在使用前制定适当的安全、健康和环境实践,并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒(TBT)委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 4.1 本试验方法用于确定矿物表面屋顶样品中沥青涂层上颗粒表面的覆盖范围。结果确定是否符合适用规范要求,或可用于比较分析。本试验方法适用于“制造”材料和已风化或经历其他类型暴露的材料。
1.1 This test method covers the determination of the hiding power of granules on a mineral-surfaced roofing sheet. The test is used primarily after an abrasion test has been conducted to determine the portion of asphaltic compound that has been exposed as a result of the abrasion test. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 This test method is used to determine the extent of coverage of the granular surfacing over the asphaltic coating in a sample of mineral-surfaced roofing. The results determine compliance with the applicable specification requirements or may be used for comparative analysis. This test method applies to both “as manufactured” material and material that has weathered or undergone other types of exposure.
分类信息
关联关系
研制信息
归口单位: D08.04
相似标准/计划/法规