1.1 本消费者安全规范建立了性能要求和测试程序，以确定全尺寸婴儿床的结构完整性。它还包含解决婴儿床角柱延伸上缠绕的设计要求，以及警告标签和教学材料的要求。它还包括婴儿床的摇篮、更衣台或类似附件，当其处于制造商建议的使用位置时，位于乘员保留区。这些附件还应符合ASTM国际标准对这些附件的适用要求。例如，固定在婴儿床上的更衣台也应符合《消费者安全规范》中的适用要求 F2388 . 本规范不包括充气产品。 1.2 在本消费者安全规范批准日期之后生产的婴儿床，除非符合本规范中包含的所有要求，否则不得通过标签或其他方式表明符合本规范。 1.3 以英寸-磅为单位的数值应视为标准值。括号中给出的值是到国际单位制的数学转换，仅供参考，不被视为标准值。 1.4 以下安全危险警告仅适用于测试方法部分第节 7. ，本规范: 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This consumer safety specification establishes performance requirements and test procedures to determine the structural integrity of full-size cribs. It also contains design requirements addressing entanglement on crib corner post extensions, and requirements for warning labels and instructional material. It also covers bassinet, changing table, or similar accessories to a crib that when in the manufacturer’s recommended use position are in the occupant retention area. These accessories shall also comply with the applicable requirements of the ASTM International standards addressing those accessories. For example, a changing table that attaches to a crib shall also comply with the applicable requirements in Consumer Safety Specification F2388 . This specification does not cover inflatable products. 1.2 No crib produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 The following safety hazards caveat pertains only to the test methods portion, Section 7 , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.