1.1 本规范涵盖了对所用PAEK材料的要求，以及对由PAEK制造的挤出、压模和注塑PAEK片材、板、棒和管棒的尺寸、工艺和性能的要求和测试方法。PAEK是一类性能不同的热塑性材料（见第3节）。 1.2 本规范中包含的性能是所涵盖的组合物所需的性能。使用第节中给出的分类系统描述了识别对专业应用重要的特定特征所需的要求 4. 。 1.3 本规范允许使用键包塑料（见第节 4. )。 1.4 这些值以英寸-磅为单位表示，并被视为所有特性和尺寸表中的标准。出于参考目的，表1中也包含了国际单位制。 1.5 以下注意事项仅适用于试验方法部分第节 11 。 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 注1: 目前还没有与该标准等效的ISO。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers requirements for the PAEK materials used and the requirements and methods of test for the dimensions, workmanship, and the properties of extruded, compression molded, and injection molded PAEK sheet, plate, rod, and tubular bar manufactured from PAEK. PAEK is a family of thermoplastic materials that differ in properties (see Section 3). 1.2 The properties included in this specification are those required for the compositions covered. Requirements necessary to identify particular characteristics important to specialized applications are described by using the classification system given in Section 4 . 1.3 This specification allows the use of key clad plastics (see Section 4 ). 1.4 The values are stated in inch-pound units and are regarded as the standard in all property and dimensional tables. For reference purposes, SI units are also included in Table 1. 1.5 The following precautionary caveat pertains only to the test method portion Section 11 , of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this standard. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.