1.ScopeZ240。0.2-1.1本标准适用于CSA Z240 RV系列休闲车中定义的休闲车。它还提供了Z240 RV系列中其他标准未涵盖的一般安全要求。1.2本标准和Z240 RV系列标准不适用于停车模型挂车，其由CSA标准CAN/CSA-Z241系列解决。Z240。1.2-1.1本标准规定了休闲车（房车除外）的车辆要求。1.2本标准规定了休闲车的联轴器、牵引架或A型架、车辆照明（仅适用于滑入式露营车）、玻璃材料和传动装置的要求。 1.3本标准包括以下性能试验:（a）耦合强度；（b） 照明设备的光度和机械性能；（c） 玻璃材料的光学和强度特性；和（d）行车制动器性能。1.4按照本标准制造的休闲车必须符合加拿大交通部出版物MVSR的适用规定。如果标准与MVSR不一致，则以后者为准。1.5本标准不禁止作为休闲车组成部分的货物运输空间，用于运输或储存牲畜、车辆（包括摩托车）、雪机或水上航行器。 Z240。3.2-1.1本标准规定了休闲车管道系统的最低安装要求和材料标准。1.2本标准不作为未经培训人员的设计规范或使用手册。Z240。4.2-1.1本标准适用于休闲车丙烷装置、附件和设备的工厂安装。注:CGA标准CAN/CGA-B149。2作为编制本标准的基础，此处未涉及的安装应参考。1.2管道、管件和配件的尺寸是基于英制（码-磅）单位的标准标称尺寸。对于其他度量，以SI（公制）单位给出的值是标准值，括号中给出的值仅供参考。 Z240。6.2/C22。2 No.148-1.1本标准规定了休闲车的电气要求，根据《加拿大电气规范》第I.1.2部分的规定，休闲车拟通过电线和连接插头连接到导线之间不超过250 V的电源或接地不超过150 V的电源，本标准不适用于（a）符合CSA标准CAN/CSA-Z241系列的驻车拖车；或（b）CSA标准Z240中描述的6伏或12伏电池驱动的车辆照明和制动布线系统。1.2，前提是该系统的导体未接触或不能与更高电压系统的导体接触。 1.3本标准的要求基于CSA标准C22。1，《加拿大电气规范》第一部分。如果未给出具体要求，则适用《加拿大电气规范》第一部分。

1. ScopeZ240.0.2-1.1 This Standard applies to recreational vehicles as defined in the CSA Z240 RV Series on recreational vehicles. It also gives general safety requirements that are not covered by the other Standards in the Z240 RV Series.1.2 This Standard and the Z240 RV Series of Standards do not apply to park model trailers, which are addressed by CSA Standards CAN/CSA-Z241 Series.Z240.1.2-1.1 This Standard sets out vehicular requirements for recreational vehicles, except motor homes.1.2 This Standard provides requirements for couplings, tongue or A- frame, vehicular lighting (for slide-in campers only), glazing materials, and running gear of recreational vehicles.1.3 This Standard includes performance tests for the following: (a) coupling strength; (b) photometric and mechanical performance of lighting equipment; (c) optical and strength properties of glazing material; and (d) service brake performance.1.4 Recreational vehicles manufactured to this Standard are required to c omply with the applicable provisions of the Transport Canada publication MVSR. Where the Standard is at variance with the MVSR, the latter takes precedence.1.5 Cargo transportation space that is an integral part of the recreational vehicle and that is intended or provided for the transportation or storage of livestock, vehicles (including motorcycles), snow machines, or water craft is not prohibited by th is Standard.Z240.3.2-1.1 This Standard sets the minimum installation requirements and material standards for plumbing systems in recreational vehicles.1.2 This Standard is not intended as a design specification or an instruction manual for untrained persons.Z240.4.2-1.1 This Standard applies to the factory installation of propane appliances, accessories, and equipment in recreational vehicles. Note: CGA Standard CAN/CGA-B149.2 was used as a basis for the preparation of this Standard and should be consulted for installations n ot covered here.1.2 The sizes of pipe, tubing, and fittings are standard nominal sizes based on imperial (yard-pound) units. For other measures, the values given in SI (metric) units are the standard, and the valu es given in parentheses are for information only.Z240.6.2/C22.2 No. 148-1.1 This Standard sets out the electrical requirements for recreational vehicles that are intended to be connected by a cord and attachment plug to a source of electrical supply not exceeding 250 V between conductors or 150 V to ground in accordance with rules of the Canadian Electrical Code, Part I.1.2, This Standard does not apply to (a) park model trailers conforming to CSA Standard CAN/CSA-Z241 Series; or (b) the 6 or 12 V battery-operated vehicular lighting and brake wiring systems that are described in CSA Standard Z240.1.2, provided that the conductors of this system are not in contact or cannot come in contact with the conductors of the higher voltage system.1.3 The requirements of this Standard are based on CSA Standard C22.1, Canadian Electrical Code, Part I. Where no specific req uirements are given, those of the Canadian Electrical Code, Part I, apply.