1.1 本试验方法涵盖了在干洗和洗涤之前或之后表征粘合、熔融和层压服装织物粘合强度的程序。 1.2 以国际单位制表示的数值应视为标准值；括号中的值仅供参考。 1.3 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 看见 6.1.1 针对特定警告。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 5.1 本试验方法用于测定粘合、熔融或层压服装面料的粘合强度，被认为适用于粘合和层压服装面料的商业装运验收试验。 5.1.1 如果两个实验室（或更多实验室）的报告测试结果之间存在实际意义上的差异，则应进行比较测试，以确定它们之间是否存在统计偏差，并使用适当的统计协助。作为最低要求，使用尽可能同质的样品进行比较试验，从与初始试验期间产生不同结果的样品相同批次的材料中提取。将相同数量的样本随机分配给每个实验室。应使用未配对数据的统计测试和测试系列之前选择的概率水平来比较相关实验室的测试结果。 如果发现偏差，必须找到并纠正其原因，或者考虑到已知偏差，必须调整该材料的未来测试结果。

1.1 This test method covers procedures for characterizing the bond strength of bonded, fused, and laminated apparel fabrics before or after drycleaning and laundering. 1.2 The values stated in SI units are to be regarded as standard; the values in parentheses are provided as information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See 6.1.1 for a specific warning. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 This test method for the determination of bond strength of bonded, fused, or laminated apparel fabrics, is considered satisfactory for acceptance testing of commercial shipments of bonded and laminated apparel fabrics. 5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing. Randomly assign specimens in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data and a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.