1.1 本规程涵盖了直接应用外部饰面系统（DEFS）现场应用的最低要求和程序。直接涂覆的外部饰面系统是使用非金属钢筋网涂覆在各种基材上的涂层系统，其中底涂层的范围不小于 1. / 16 在里面（1.6毫米）至 3. / 32 在里面（2.4 mm），取决于钢筋网的质量。该底涂层随后覆盖有一层面漆，该面漆具有多种纹理和颜色。 1.2 以英寸-磅为单位的数值应视为标准值。括号中给出的度量值是近似值，仅供参考。 1.3 本标准可能涉及危险材料、操作和设备。本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 4.1 本规程规定了直接应用外部饰面系统的最低要求。材料、混合物和细节的要求应包含在项目计划和规范中。

1.1 This practice covers the minimum requirements and procedures for field application of Direct-applied Exterior Finish Systems (DEFS). Direct-applied exterior finish systems are coating systems applied over various substrates with non-metallic reinforcing mesh, in which the base coat ranges from not less than 1 / 16 in. (1.6 mm) to 3 / 32 in. (2.4 mm) in dry thickness, depending on the mass of the reinforcing mesh. This base coat is subsequently covered with a finish coat that is available in a variety of textures and colors. 1.2 The values stated in inch-pound units are to be regarded as the standard. The metric values given in parentheses are approximate and are provided for information purposes only. 1.3 This standard may involve hazardous materials, operations and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 This practice provides minimum requirements for the application of Direct-applied Exterior Finish Systems. The requirements for materials, mixtures, and details shall be contained in the project plans and specifications.