ISO 11296-2:2018与ISO 11296-1共同规定了地下无压排水和污水管网改造中作为连续管道安装的塑料管道系统的一部分的管道和配件的要求和试验方法。适用于三种不同类型的聚乙烯（PE）管: -PE实心壁单层管（公称外径dn），包括任何识别条纹； -按照附录A的规定，管道内外各有一层或两层共挤出层的PE管（总外径，dn），其中所有层具有相同的MRS等级； -聚乙烯涂层管道（外径，dn），管道外部具有可剥离、连续的热塑性附加层（“涂层管道”），见附录a。 此外，ISO 11296-2:2018涵盖: -通过对接熔合方式连接管道长度； -聚乙烯制成的预制和注塑配件。

ISO 11296-2:2018, in conjunction with ISO 11296-1, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of underground non-pressure drainage and sewerage networks. It is applicable to polyethylene (PE) pipes of three different types: - PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes; - PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outside diameter, dn), as specified in Annex A, where all layers have the same MRS rating; - PE coated pipes (outside diameter, dn) having a peelable, contiguous, thermoplastics additional layer on the outside of the pipe ("coated pipe"), see Annex A. In addition, ISO 11296-2:2018 covers: - jointing of pipe lengths by means of butt fusion; - fabricated and injection-moulded fittings made of PE.