1.1 本规范涵盖了标称螺纹直径为M6至M36的商用锻造有色金属螺母的要求，包括许多常用合金和一般服务应用。 1.2 本规范涵盖了与本规范涵盖的螺母一起使用的适用螺栓、带帽螺钉和螺柱 F468M . 1.3 以国际单位制表示的数值应视为标准值。本标准不包括其他计量单位。 注1: 本规范是规范的公制伴侣 F467 . 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 11.1 为了确定是否符合本规范所列特性要求的规定限值，应按照惯例对观察值或计算值进行四舍五入 E29年 .

1.1 This specification covers the requirements for commercial wrought nonferrous nuts in nominal thread diameters M6 to M36 inclusive in a number of alloys in common use and intended for general service applications. 1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this specification are covered by Specification F468M . 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. Note 1: This specification is the metric companion of Specification F467 . 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 11.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29 .