1.1 本规程涵盖了木包装材料（WPM）的建议处理或标记规程的制定，或两者兼有，并有助于识别有关植物检疫处理、预期使用周期、维修、用于制造或回收的特定规范以及其他用户指定特性的WPM。 1.2 该实践确定了根据行业、政府或国际公认标准处理或标记的WPM，或两者兼而有之。 1.3 以英寸磅为单位的数值应视为标准。括号中给出的值是国际单位制的数学转换，仅供参考，不被视为标准。 1.4 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。 ====意义和用途====== 4.1 本规程规定了处理、标记或同时使用植物检疫处理、预期使用周期或两者、修理、使用规范和其他指定特性的永久标识的WPM的标准。 4.2 应在确保材料符合适用规范后，对WPM进行标记。

1.1 This practice covers the development of recommended treatment, or marking practices, or both, for wood packaging materials (WPM) and aids in identifying WPM as to phytosanitary treatment, intended service cycles, repair, the specific specification used to manufacture or recycle, and other user designated characteristics. 1.2 This practice identifies WPM treated, or marked, or both in accordance with industry, government, or international recognized standards. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 This practice establishes the criteria to treat, or mark, or both WPM with permanent identification for the phytosanitary treatment, or intended service cycle, or both, repair, specification used, and other designated characteristics. 4.2 The marking of the WPM shall be performed after ensuring the material complies with the applicable specification.