1.1 本试验方法 2. 包括液化石油气（LP）中硫化氢的检测。测试的灵敏度约为4 毫克/米 3. （每100克含0.15至0.2克硫化氢 英尺 3. )气体。 1.2 以国际单位制表示的值应视为标准值。SI单位后括号中给出的值仅供参考，不视为标准值。 1.3 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《国际标准、指南和建议制定原则决定》中确立的国际公认标准化原则制定的。 =====意义和用途====== 5.1 液化石油气及其燃烧产物不得对与其接触的材料产生过度腐蚀。H的潜在人员暴露危险 2. S也使硫化氢的检测和测量变得重要，即使在低浓度下也是如此。此外，在某些情况下，气体的气味不会令人反感。 （见规范 835美元 以及GPA 2140。）

1.1 This test method 2 covers the detection of hydrogen sulfide in liquefied petroleum (LP) gases. The sensitivity of the test is about 4 mg/m 3 (0.15 to 0.2 grain of hydrogen sulfide per 100 ft 3 ) of gas. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 Liquefied petroleum gases and their products of combustion must not be unduly corrosive to the materials with which they come in contact. The potential personnel exposure hazards of H 2 S also make the detection and measurement of hydrogen sulfide important, even in low concentrations. In addition, in some cases the odor of the gases shall not be objectionable. (See Specification D1835 and GPA 2140.)