1.1 这些测试方法涵盖了单位面积织物质量的测量（传统上称为“织物重量”），适用于大多数织物。 1.2 有四个批准的选项: 1.2.1 选项A- 整件、卷、螺栓或切割（截面 7. ). 1.2.2 选项B- 全宽样品（截面 8. ). 1.2.3 选项C- 小样本织物（第 9 ). 1.2.4 选项D- 窄织物（第 10 ). 1.3 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值不一定是精确的等价物；因此，为确保符合本标准，每个系统应独立使用，且两个系统的值不得组合。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 These test methods cover the measurement of fabric mass per unit area (traditionally referred to as “fabric weight”) and are applicable to most fabrics. 1.2 There are four approved options: 1.2.1 Option A— Full Piece, Roll, Bolt or Cut (Section 7 ). 1.2.2 Option B— Full Width Sample (Section 8 ). 1.2.3 Option C— Small Swatch of Fabric (Section 9 ). 1.2.4 Option D— Narrow Fabrics (Section 10 ). 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.