1.1 本规范涵盖了波纹聚乙烯（PE）管道和配件的材料、工艺、尺寸、穿孔、管道刚度、伸长率、接头分离阻力、挤出聚乙烯质量、脆性、粘合和标记的要求和测试方法。其涵盖标称尺寸3英寸。[76毫米]，4英寸。[102毫米]，5英寸。[127毫米]6英寸。[152毫米]，8英寸。[203毫米]，10英寸。[254毫米]，12英寸。[305毫米]，15英寸。[381毫米]，18英寸。[457毫米]和24英寸。[610毫米]。 1.2 本规范涵盖管状挤出、螺旋层压和旋转模压波纹聚乙烯管。 1.3 以英寸-磅为单位的数值应视为标准值。括号中给出的值是到国际单位制的数学转换，仅供参考，不被视为标准值。 1.4 以下预防性警告仅适用于试验方法部分第节 9 ，本规范: 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers requirements and test methods for materials, workmanship, dimensions, perforations, pipe stiffness, elongation, joint separation resistance, quality of extruded polyethylene, brittleness, bond, and marking of corrugated polyethylene (PE) pipe and fittings. It covers nominal sizes 3 in. [76 mm], 4 in. [102 mm], 5 in. [127 mm] 6 in. [152 mm], 8 in. [203 mm], 10 in. [254 mm], 12 in. [305 mm], 15 in. [381 mm], 18 in. [457 mm], and 24 in. [610 mm]. 1.2 This specification covers tubularly extruded, spirally laminated, and rotationally molded corrugated polyethylene pipe. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 The following precautionary caveat pertains only to the test method portion, Section 9 , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.