BS EN ISO 80079-37:2016规定了非电气设备的设计和施工要求 拟用于爆炸性环境的设备，受 保护结构安全“c”，控制点火源“b”和液体浸入“k”。ISO/IEC 80079的本部分补充和修改了ISO 80079-36中的要求。 如果本标准的要求与ISO 80079-36的要求冲突 优先考虑本标准的要求。保护类型“c”、“k”和“b”不适用于I组EPL Ma，无需额外的 防护措施。本标准中描述的点火保护类型可以单独使用，也可以单独使用 相互结合，以满足第一组、第二组的设备要求， 根据ISO 80079-36中的点火危险评估，分为第三组。交叉引用:IEC 60079-0IEC TS 60079-32-1IEC 60529ISO 281ISO 1813ISO 9563ISO 4413ISO 4414ISO 19353ISO 80079- 36:2016EN 13237EN 13501-1IEC 60079-6IEC 60079-20-1IEC 61508-1:2010IEC 61508-2:2010IEC 61508-3:2010IEC 61508-4:2010IEC 61508-5:2010IEC 61508-6:2010IEC 61511IEC 62061:2005IEC 80079-38ISO 13849-1:2006EN 13478EN 14986EN 50303:2000DIN 740-22014/34/EU购买本文件时可提供的所有现行修改件。

BS EN ISO 80079-37:2016 specifies the requirements for the design and construction of nonelectrical equipment, intended for use in explosive atmospheres, protected by the types of protection constructional safety "c", control of ignition source "b" and liquid immersion "k".This part of ISO/IEC 80079 supplements and modifies the requirements in ISO 80079-36. Where a requirement of this standard conflicts with the requirement of ISO 80079-36 the requirement of this standard takes precedence.Types of Protection "c", "k" and "b" are not applicable for Group I, EPL Ma without additional protective precautions.The types of ignition protection described in the standard can be used either on their own or in combination with each other to meet the requirements for equipment of Group I, Group II, and Group III depending on the ignition hazard assessment in ISO 80079-36.Cross References:IEC 60079-0IEC TS 60079-32-1IEC 60529ISO 281ISO 1813ISO 9563ISO 4413ISO 4414ISO 19353ISO 80079-36:2016EN 13237EN 13501-1IEC 60079-6IEC 60079-20-1IEC 61508-1:2010IEC 61508-2:2010IEC 61508-3:2010IEC 61508-4:2010IEC 61508-5:2010IEC 61508-6:2010IEC 61508-7:2010IEC 61511IEC 62061:2005IEC 80079-38ISO 13849-1:2006EN 13478EN 14986EN 50303:2000DIN 740-22014/34/EUAll current amendments available at time of purchase are included with the purchase of this document.