1.1 本规范规定了电气工人橡胶绝缘手套上佩戴的防护装置的规范和测试要求。 1.2 本规范中规定的防护装置应紧贴在规范中规定的橡胶绝缘手套上 D120型 不会对橡胶绝缘手套造成机械损坏。允许在手腕上扣带。 1.3 本规范涵盖了不影响橡胶绝缘手套完整性的材料或材料组合的使用。 1.4 规格 F696 用于确定本规范的最低要求。 1.5 如果单独使用，符合本规范的保护器不提供任何电击保护。 1.6 本规范规定了保护器在受控条件下对电弧、刺穿和切割的响应。 1.6.1 现场条件不会与测试方法直接相关。 1.7 除非另有说明，否则以国际单位制表示的数值应视为标准。看见 IEEE/ASTM SI-10 . 1.8 以下安全危险警告仅适用于试验方法部分，章节 6. 和 7. ，符合本规范。 本标准并非旨在解决与其使用相关的所有安全问题（如有）。 本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.9 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification establishes specifications and test requirements for protectors to be worn over electrical workers’ rubber insulating gloves. 1.2 It is intended that the protectors specified herein fit snugly over rubber insulating gloves specified in Specification D120 without causing mechanical damage to the rubber insulating glove. Cinching at the wrist is allowed. 1.3 This specification covers the use of a material or combination of materials which do not compromise the integrity of the rubber insulating glove. 1.4 Specification F696 was used to establish minimums for this specification. 1.5 Protectors meeting this specification do not provide any electrical shock protection if used on their own. 1.6 This specification specifies the response of protectors to electric arc, puncture and cut under controlled conditions. 1.6.1 Field conditions will not directly correlate to testing methods. 1.7 The values stated in SI units are to be regarded as the standard except as noted. See IEEE/ASTM SI-10 . 1.8 The following safety hazards caveat pertains only to the test method portion, Sections 6 and 7 , of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.