1.1本规范是对主轴颈或曲柄销为4英寸的锻钢曲轴进行超声波检查的验收规范。直径为[100 mm]或更大。 1.2本规范涵盖了所需的测试设备和要遵循的测试程序，并定义了关键和非关键区域以及验收极限。 1.3本规范旨在涵盖用于中高速柴油发动机的连续颗粒流（CGF）曲轴以及用于其他应用的实心（平板）锻造曲轴。 1.4以英寸-磅单位或国际单位制（公制）单位表示的数值应单独视为标准。在正文和表格中，国际单位制显示在括号中。每个系统中规定的值应独立于其他系统使用。合并两个系统的值可能会导致不符合规范。 1.5除非订单规定了适用的“M”规格名称，否则应使用英寸-磅单位。 1.6 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。

1.1 This is an acceptance specification for the ultrasonic inspection of forged steel crankshafts having main bearing journals or crankpins 4 in. [100 mm] or larger in diameter. 1.2 This specification covers the testing equipment required and the test procedure to be followed, and it defines the critical and noncritical areas and limits of acceptance. 1.3 This specification is intended to cover both continuous grain flow (CGF) crankshafts for medium and high speed diesel engines as well as solid (slab) forged crankshafts for other applications. 1.4 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as the standard. Within the text and tables, the SI units are shown in brackets. The values stated in each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.5 Unless the order specifies the applicable "M" specification designation, the inch-pound units shall be used. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.