1.1 本规范涵盖了用作喷涂聚氨酯泡沫屋面系统保护涂层的单组分湿固化弹性聚氨酯聚合物涂层。 1.2 本规范不提供应用指南。 1.3 以国际单位制或英寸磅单位表示的数值应单独视为标准值。每个系统中规定的值可能不完全相等；因此，每个系统应独立使用。将两个系统的值合并可能导致不符合标准。 1.4 以下预防性警告仅适用于测试方法部分，章节 5. 和 6. . 1.5 本标准并不旨在解决与其使用相关的所有安全问题（如有）。 本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《国际标准、指南和建议制定原则决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers a single component, moisture cured, elastomeric urethane polymer coating used as a protective coating for spray polyurethane foam roofing systems. 1.2 This specification does not provide guidance for application. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.4 The following precautionary caveat pertains only to the test method portions, Sections 5 and 6 . 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.