本文件给出了测定骨料百分之十细料值（TFV）的试验方法。该方法给出了在逐渐施加的压缩荷载下骨料破碎阻力的相对测量值。 它包括两套程序: -第一个程序适用于在干燥条件下测试的骨料；和 -第二个程序适用于在浸泡条件下测试的骨料。 注1:通常，试验可在干燥条件下进行。但是，如果必要，主管工程师可以选择在浸泡条件下对其进行测试。 该方法适用于不同强度的骨料，包括弱骨料和强骨料。适用于标准骨料，即通过14.0 mm试验筛，并保留在10.0 mm试验筛上。 国家标准也适用于本试验所需的骨料粒径分数。如果无法获得该确定粒径分数，则可对附录A中给出的其他粒径进行试验。由于缺乏可用数据，无法将非标准粒径与标准粒径骨料的结果进行比较。 注2:在各自的国家标准中，分级划分允许有微小变化。

This document gives the test method for determination of ten percent fines value (TFV) of aggregates. This method gives a relative measure of the resistance of the aggregate crushing under the gradually applied compressive load. It covers two sets of procedures: — the first procedure is applicable for aggregates tested in dry condition; and — the second procedure is applicable for aggregates tested in a soaked condition. NOTE 1 Generally, the test can be done under dry conditions. However, the engineer in charge can choose to test them in soaked condition, if necessary. The method is applicable to aggregates of different strengths covering both weak and strong aggregates. It is applicable to standards aggregates, i.e. passing a 14,0 mm test sieve and retained on 10,0 mm test sieve. National standards can also exist for the aggregate size fraction to be taken for this test. In case this definite size fraction is not available, the test can be made on other sizes, given in Annex A. The comparison of results of non-standard sizes with standard size aggregates is not possible due to lack of available data. NOTE 2 Minor variations in grading divisions can be allowed in respective national standards.