1.1 本规范涵盖了机构和家庭环境中使用的编织和针织厨房毛巾、抹布、抹布、毛巾、毛巾、手巾、浴巾和浴巾产品的重要特定性能特征的评估。 1.2 本规范可通过买方和供应商之间的相互协议用于制定采购规范要求。 1.3 中的要求 表1和 2. 适用于与织物方向相关的那些特性的长度和宽度方向。 1.4 本规范不适用于服装用涂层和层压产品、非织造产品或毛圈布。 1.5 本标准并不旨在解决与其使用相关的所有安全问题（如有）。 本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。 ====意义和用途====== 5.1 根据买方和供应商之间的相互协议，用于该最终用途的编织或针织产品应满足中列出的所有要求 表1 本规范的毛圈布产品和 表2 用于非毛圈产品。 5.2 人们认识到，出于时尚或美观的目的，由这些织物制成的物品的最终消费者可能会发现可接受的产品不符合 表1 或 表2 。因此，中列出的一个或多个要求 表1 或 表2 可通过买方和卖方之间的共同协议进行修改。 5.2.1 在这种情况下，任何对规范的引用都应规定:本产品符合ASTM规范63-707，但以下特性除外。 5.3 如果买方和供应商之间没有达成采购前协议，并且在存在争议的情况下 表1 或 表2 仅用作指南。如中所述 5.2 ，消费者的最终需求决定了任何特定风格的不同性能参数。 5.4 特定性能和测试方法的重要性和用途在规定测试方法的适当章节中进行了讨论。

1.1 This specification covers the evaluation of specific performance characteristics of importance in woven and knitted kitchen towel, dishcloth, crash towel, huck towel, washcloth, hand towel, bath towel, and bath sheet products for use in institutional and household environments. 1.2 This specification may be used by mutual agreement between the purchaser and the supplier to establish purchasing specification requirements. 1.3 The requirements in Tables 1 and 2 apply to the length and width directions for those properties where fabric direction is pertinent. 1.4 This specification is not applicable for coated and laminated products, nonwoven products, or terry fabrics used for apparel. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 Upon mutual agreement between the purchaser and the supplier, woven or knitted products intended for this end use should meet all of the requirements listed in Table 1 of this specification for terry products and Table 2 for non terry products. 5.2 It is recognized that for purposes of fashion or aesthetics the ultimate consumer of articles made from these fabrics may find acceptable products that do not conform to all of the requirements in Table 1 or Table 2 . Therefore, one or more of the requirements listed in Table 1 or Table 2 may be modified by mutual agreement between the purchaser and the seller. 5.2.1 In such cases, any references to the specification shall specify that: This product meets ASTM Specification 63-707 except for the following characteristic(s). 5.3 Where no prepurchase agreement has been reached between the purchaser and the supplier, and in case of controversy, the requirements listed in Table 1 or Table 2 are intended to be used as a guide only. As noted in 5.2 , ultimate consumer demands dictate varying performance parameters for any particular style. 5.4 The significance and use of particular properties and test methods are discussed in the appropriate sections of the specified test methods.