1.1 本规范涵盖用于管道、管拱、拱、地下通道、箱涵施工的波纹铝合金结构板，以及现场组装的特殊形状。还描述了合适的紧固件。管道、拱门和其他形状通常用于排水、行人和车辆地下通道以及公用工程隧道。铝箱涵形状见规范 B864/B864M 。 1.2 本规范不包括垫层、回填或覆土荷载与管道板厚之间的关系的要求。 经验表明，该产品的成功性能取决于板材厚度、垫层和回填类型的正确选择、工厂的受控制造以及安装过程中的注意事项。买方必须将上述因素以及现场安装的腐蚀和磨损要求与板材厚度联系起来。实践中给出了波纹铝结构板管的结构设计和正确的安装程序 B790/B790M 和 B789/B789M 分别地实践中给出了使用寿命周期成本分析技术评估使用波纹金属管的替代排水系统设计的程序 A930 。 1.3 以英寸磅单位或国际单位制表示的数值应单独视为标准。每个系统中规定的数值并不完全相等；因此，每个系统应独立使用。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers corrugated aluminum alloy structural plate used in the construction of pipe, pipe-arches, arches, underpasses, box culverts, and special shapes for field assembly. Appropriate fasteners are also described. The pipe, arches, and other shapes are generally used for drainage purposes, pedestrian and vehicular underpasses, and utility tunnels. Aluminum box culvert shapes are covered in Specification B864/B864M . 1.2 This specification does not include requirements for bedding, backfill, or the relationship between earth cover load and plate thickness of the pipe. Experience has shown that the successful performance of this product depends upon the proper selection of plate thickness, type of bedding and backfill, controlled manufacture in the plant, and care in the installation. The purchaser must correlate the above factors and also the corrosion and abrasion requirements of the field installation with the plate thickness. The structural design of corrugated aluminum structural plate pipe and the proper installation procedures are given in Practices B790/B790M and B789/B789M , respectively. A procedure for using life-cycle cost analysis techniques to evaluate alternate drainage system designs using corrugated metal pipe is given in Practice A930 . 1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.