范围1。1本标准提供了基于接头极限载荷或极限滑移的基本程序，用于测定嵌入锯材和结构复合木材构件中的桁架板齿的抗侧强度和抗侧滑移性。1.2本标准规定了当用于桁架板上的钉子时，嵌入木材构件中的钉子的抗侧向强度和抗侧向滑动性的测定。当采用本标准时，“齿”一词应理解为“钉”一词。1.3本标准提供了基于桁架板极限强度的基本程序，用于确定板净截面的拉伸和剪切强度。1.4通过本文所述的试验方法和程序确定的承载力，并根据制造试验桁架板所用板材的极限抗拉强度变化进行校正，将产生可调整用于工程设计的值，如CSA O86中的规定。

Scope1.1This Standard provides basic procedures based on joint ultimate load or a limiting slip for the determination of the lateral strength resistance and lateral slip resistance of truss plate teeth embedded in sawn and structural composite lumber members.1.2This Standard provides for the determination of the lateral strength resistance and lateral slip resistance of nails embedded in lumber members when used in nail-on truss plates. When this Standard is so applied, the word "tooth" is understood to be replaced by the word "nail".1.3This Standard provides basic procedures based on truss plate ultimate strength for the determination of the tensile and shear strengths of the net section of the plates.1.4The capacities determined by testing methods and procedures described herein, and corrected for the variations in the ultimate tensile strength of the plate material used in the manufacture of the test truss plates, will yield values that may be adjusted for use in engineering design, such as specified in CSA O86.