1.1本试验方法包括评估工厂在厚度为0.65至1.25 mm（0.025至0.05 in.）的钢上涂覆的富锌底漆/铬酸盐复合涂层的成形性和附着力线圈涂层行业中使用的典型产品。 1.2成型前的除油程度、胶带技术和胶带粘合强度的差异可能会影响粘合等级。 1.3以国际单位制表示的数值应视为标准。括号中给出的值仅供参考。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。 有关具体的危险说明，请参阅第7节。 ====意义和用途====== 变形和胶带联合试验的结果与涂层金属在工厂应用中承受冲压的能力有关。 该测试可用于控制制造过程或在开发工作中改进产品。 应认识到，由于试验条件和成型机的变化，结果的可变性持续存在。

1.1 This test method covers the evaluation of the formability and adhesion of factory applied zinc-rich primer/chromate complex coatings on steel with thicknesses of 0.65 to 1.25 mm (0.025 to 0.05 in.) typical of those used in the coil coating industry. 1.2 The degree of oil removal prior to forming, the techniques of taping, and differences in adhesive strength of the tape can affect the adhesion rating. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7. ====== Significance And Use ====== The results of the combined deformation and tape test are related to the ability of the coated metal to withstand stamping in factory applications. This test can be used to control the manufacturing process or in development work to improve the product. It should be recognized that variability in the results persist due to the test conditions and forming machine variations.