1.1 本安全规范旨在定义规范中要求的翻车约束装置的试验方法和其他要求 F2057 . 1.2 本规范仅评估翻车约束的强度，不涉及翻车约束的现场性能。 1.3 以英寸-磅为单位的数值应视为标准值。括号中给出的值是到国际单位制的数学转换，仅供参考，不被视为标准值。 1.4 以下安全危险警告仅适用于测试程序部分第节 4. ，符合本安全规范。 本标准并非旨在解决与其使用相关的所有安全问题（如有）。 本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This safety specification is intended to define the test method and other requirements for tipover restraints as required in Specification F2057 . 1.2 This specification assesses the strength of the tipover restraint only, and does not address the in situ performance of the tipover restraint. 1.3 The values stated in inch‐pounds units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 The following safety hazard caveat pertains only to the test procedure portion, Section 4 , of this safety specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.