ISO 2063-2:2017规定了通过锌，铝或其合金的热喷涂涂层的钢结构，部件或部件的腐蚀保护要求。 ISO 2063-2:2017规定了表面处理，热喷涂，测试和后处理涂料制造商的要求。密封涂层。 ISO 2063-2:2017适用于车间新制造的金属防腐涂料，以及现场和现场维修后的组装。 给出涂层规格中规定的涂层厚度，最小粘合强度和表面条件的要求。 给出了新的生产和维护以及防腐工程监督的合适工艺步骤和质量保证措施的建议。 ISO 2063-2:2017涵盖了在50℃至200℃之间的温度范围内热喷锌，铝及其合金的防腐蚀应用。铝的耐热保护涂层由ISO 17834涵盖，不在ISO 2063-2:2017范围内。 ISO 2063-2:2017规定了喷涂和检测人员对设备，工作场所和资质的要求。 注意ISO 2063-1:2017是致力于设计师和防腐系统的规划工程师。

ISO 2063-2:2017 specifies requirements for corrosion protection of steel structures, components or parts, which are coated by thermal spraying of zinc, aluminium or their alloys. ISO 2063-2:2017 specifies requirements for coating manufacturers of surface preparation, thermal spraying, testing and post treatments, e.g. sealing of the coating. ISO 2063-2:2017 applies to metallic corrosion protection coatings in the case of new fabrication in the workshop, as well as on-site and for repair on-site after assembly. Requirements for coating thickness, minimum adhesive strength and surface conditions, specified in a coating specification, are given. Recommendations are given for suitable process steps and quality assurance measures for new production and maintenance and for supervising of corrosion protection works. ISO 2063-2:2017 covers the application of thermal-sprayed zinc, aluminium and their alloys for protection against corrosion in the temperature range between?50 °C to +200 °C. Heat-resistant protective coatings of aluminium are covered by ISO 17834 and are not in the scope of ISO 2063-2:2017. ISO 2063-2:2017 specifies requirements for the equipment, the working place and the qualification of the spray and testing personnel. NOTE ISO 2063‑1:2017 is addressed to the designer and to the planning engineer of corrosion protection system.