1.1 本规范涵盖了新型全封闭线装托盘式木箱的制造，该木箱拟用作国内和海外装运一般材料和物资的容器，重量不超过2500 lb[1134 kg]（见 4.1 和 10.1 ). 1.2 线装托盘式木箱的性能取决于其制造组件；因此，规定了反映不同性能的各种类型、类别和处理（见 4. ). 然而，本规范不涵盖所有大气、搬运、运输和储存条件下的线装托盘式木箱性能。 1.3 可接受并允许使用其他施工方法或技术（参见 5.1.11 )，前提是由此产生的包装系统的性能应与使用这些指定材料和程序产生的性能相同或更好。实践中提供的适当分配周期 D4169 可用于制定比较程序和标准。 1.4 单位- 以英寸-磅或国际单位制表示的数值应单独视为标准值。在文本中，国际单位显示在括号中。每个系统中规定的值不是精确的等价物；因此，每个系统必须相互独立使用。将两个系统的值合并可能会导致不符合标准。有关单位转换的信息，请参阅。 1.5 本标准并非旨在解决与其使用相关的所有安全问题（如有）。 本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers the fabrication of new fully enclosed wirebound pallet-type wood boxes intended for use as containers for domestic and overseas shipment of general materials and supplies, not exceeding 2500 lb [1134 kg] (see 4.1 and 10.1 ). 1.2 Wirebound pallet-type wood box performance is dependent on its fabricated components; therefore, a variety of types, classes, and treatments reflecting varied performance are specified (see 4 ). This specification, however, does not cover wirebound pallet-type wood box performance under all atmosphere, handling, shipping, and storage conditions. 1.3 The use of other construction methods or techniques is acceptable and permitted (see 5.1.11 ), provided the resulting packaging systems shall be of equal or better performance than would result from the use of these specified materials and procedures. The appropriate distribution cycle provided in Practice D4169 can be used to develop comparative procedures and criteria. 1.4 Units— The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. See for conversion of units. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.