BS PD IEC/TS 62735-1:2015是一项技术规范，适用于插头和固定插座 对于带有两个有源触点和一个接地触点的I类设备，额定功率为 功率为2.6千瓦，额定电压范围为294伏至400伏直流电。它们旨在为直流电供电。 仅限信息和通信技术设备，产品符合IEC 60950标准。IEC 62735本部分规定的附件适用于普通用户 数据中心的人员，仅在定义了直流电压分配系统值的情况下 如下所示:380 V，对于无备用电池或有电压的安装，公差为±20 V 监管体系；380 V，电压范围为294 V至400 V，适用于配备备用电池的安装 电压调节得不到保证；每个带电导体和接地之间的电压值不超过200 V d。 C 正常运行期间；有两个异常电压范围（持续时间低于10分钟）:260 V至294 V，以及400 V至410 V。当带电触点之间的电压为400 V d.c.时，插头和插座的最大电流为6.5 A；当带电触点之间的电压为294 V d.c.时，插头和插座的最大电流为8.8 A；当带电触点之间的电压降至260 V d.c.时，插头和插座的最大电流可升至10 A 最多10分钟。放电时，带电导体之间的电压可降至260 V d.c 蓄电池电量达到断开水平。结果是电流 相应增加。IEC 62735本部分规定的附件无需维护。IEC 62735本部分涵盖的插头和插座拟用于基本保护、过电流保护（每个插座的电流小于等于8.8 A）的电路中- 插座或多个插座），故障保护（间接接触保护）和附加保护已得到保证。交叉引用:IEC 60050-151:2001IEC 60068-2-31IEC 60227IEC 60245IEC 60352-2IEC 60423IEC 60512-12-1IEC 60512-12-2IEC 60529IEC 60695-2-11IEC 61032IEC 61210ISO 1456IEC 60068-2-30IEC 60364IEC 60417ISO/IEC指南51购买本文件时提供的所有当前修订版均包括在内。

BS PD IEC/TS 62735-1:2015, which is a Technical Specification, applies to plugs and fixed socketoutlets for class I equipment with two active contacts plus an earthing contact, a rated power of 2,6 kW and a rated voltage range from 294 V to 400 V d.c. They are intended to power d.c. information and communication technology equipment only, products according to IEC 60950.The accessories according to this part of IEC 62735 are intended to be used by ordinary persons in data centres only where the value of the d.c. voltage distribution system is defined as follows:380 V with a tolerance of ±20 V for installations with no backup battery or with a voltage regulation system;380 V with a voltage range of 294 V to 400 V for installations with a backup battery where voltage regulation is not guaranteed;the voltage value between each live conductor and earth does not exceed 200 V d.c. during normal operation;there are two abnormal voltage ranges (duration below 10 min):260 V up to 294 V, andabove 400 V to 410 V.The maximum current of the plug and the socket-outlet is6,5 A when the voltage between live contacts is 400 V d.c.,8,8 A when the voltage between live contacts is 294 V d.c.and can rise up to 10 A when the voltage between live contacts decreases to 260 V d.c. for 10 min maximum.The voltage between live conductors can fall down to 260 V d.c. when the voltage discharge value of the battery reaches the disconnecting level. The consequence is that the current increases accordingly.The accessories according to this part of IEC 62735 do not require maintenance.Plugs and socket-outlets covered by this part of IEC 62735 are intended for use in circuits wherebasic protection,an overcurrent protection (of 8,8 A or less for each socket-outlet or multiple socket-outlet),the fault protection (indirect contact protection), andadditional protectionare already assured.Cross References:IEC 60050-151:2001IEC 60068-2-31IEC 60227IEC 60245IEC 60352-2IEC 60423IEC 60512-12-1IEC 60512-12-2IEC 60529IEC 60695-2-11IEC 61032IEC 61210ISO 1456IEC 60068-2-30IEC 60364IEC 60417ISO/IEC Guide 51All current amendments available at time of purchase are included with the purchase of this document.