1.1 本规范涵盖了通过将适当制备的钢筋浸入锌熔池中而涂有保护性锌涂层的钢筋。 附注1: 在本规范中，镀锌厂被标识为制造商。 1.2 工地施工作业指南见 附录X1 . 1.3 镀锌（镀锌）钢筋与非镀锌钢模板的使用指南见 附录X2 . 1.4 本说明书的文本参考了提供解释材料的注释和脚注。这些注释和脚注（表格中的除外）不应被视为规范的要求。 1.5 本规范适用于英寸-磅单位（如规范A767）或国际单位制单位（如规范A767M）的订单。1.6 以英寸-磅单位或国际单位制单位表示的值应单独视为标准值。在正文中，SI单位显示在括号中。每个系统中陈述的值可能不完全等同。因此，每个系统应独立使用。合并两个系统的值可能导致不符合本规范。 1.7 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers steel reinforcing bars with protective zinc coatings applied by immersing the properly prepared reinforcing bars into a molten bath of zinc. Note 1: The galvanizer is identified throughout this specification as the manufacturer. 1.2 Guidelines for construction practices at the job-site are presented in Appendix X1 . 1.3 Guidelines for use of zinc-coated (galvanized) reinforcing bars with non-galvanized steel forms are presented in Appendix X2 . 1.4 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables) shall not be considered as requirements of the specification. 1.5 This specification is applicable for orders in either inch-pound units (as Specification A767) or SI units (as Specification A767M). 1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents. Therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.