首页 馆藏资源 舆情信息 标准服务 科研活动 关于我们
历史 ASTM F2919/F2919M-12(2018)
到馆提醒
收藏跟踪
购买正版
Standard Specification for Welded Wire Mesh Fence Fabric (Metallic-Coated or Polymer Coated) with Variable Mesh Patterns or Meshes Greater than 6 in.<sup>2</sup > [3871 mm<sup>2</sup>] in Panels 面板中具有可变网格图案或大于6 in.<sup>2</sup>[3871 mm<sup>2</sup>]网格的焊接钢丝网围栏织物(金属涂层或聚合物涂层)的标准规范
发布日期: 2018-03-01
1.1 本规范涵盖由钢丝或金属涂层钢丝制成的焊接钢丝网围栏织物。金属涂层织物可在制造后进行聚合物涂层。 1.2 根据涂层类型,焊接钢丝网围栏织物有四种类型,如第节所述 4. . 1.3 本规范适用于英寸-磅单位或国际单位制的订单。以英寸-磅或国际单位制表示的数值应单独视为标准。在文本中,国际单位显示在括号中。两个系统中的值不是精确等价的;因此,每个系统应独立使用,不得以任何方式组合值。 1.4 本规范引用了注释和脚注,这些注释和脚注提供了解释性材料。 这些注释和脚注(不包括表和图中的注释和脚注)不应视为本规范的要求。 1.5 以下安全隐患警告仅适用于试验方法部分, 13.4 ,本规范: 本标准并非旨在解决与其使用相关的所有安全问题(如有)。本标准的用户有责任在使用前制定适当的安全、健康和环境实践,并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒(TBT)委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。
1.1 This specification covers welded wire mesh fence fabric produced from steel wire or metallic-coated steel wire. The metallic-coated fabric may be polymer coated after fabrication. 1.2 Welded wire mesh fence fabric is produced in four types, based on the kind of coating, as described in Section 4 . 1.3 This specification is applicable to orders in either inch-pound units or SI units. Values stated in either inch-pound or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values in the two systems are not exact equivalents; therefore, each system shall be used independent of the other, without combining values in any way. 1.4 This specification references notes and footnotes, which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this specification. 1.5 The following safety hazards caveat pertains only to the test methods portion, 13.4 , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
分类信息
关联关系
研制信息
归口单位: F14.35
相似标准/计划/法规
现行
ASTM F2453/F2453M-14(2025)
Standard Specification for Welded Wire Mesh Fence Fabric (Metallic-Coated or Polymer Coated) for Meshes of 6 in.2  [3871 mm2] or Less, in Panels or Rolls, with Uniform Meshes
网目尺寸为6英寸2[3871 mm2]或更小的焊接金属丝网栅栏织物(金属涂层或聚合物涂层)的标准规范
2025-01-01
现行
ASTM F2919/F2919M-12(2025)
Standard Specification for Welded Wire Mesh Fence Fabric (Metallic-Coated or Polymer Coated) with Variable Mesh Patterns or Meshes Greater than 6 in.2 [3871 mm2] in Panels
具有可变网目图案或网目大于6 in.2[3871 mm2]的焊接金属丝网栅栏织物(金属涂层或聚合物涂层)的标准规范
2025-01-01
现行
ASTM A116-22
Standard Specification for Metallic-Coated, Steel-Woven Wire Fence Fabric
金属涂层钢丝编织栅栏织物的标准规范
2022-04-01
现行
ASTM A817-12(2017)
Standard Specification for Metallic-Coated Steel Wire for Chain-Link Fence Fabric and Marcelled Tension Wire
链条围栏织物和马丝拉伸丝的金属涂层钢丝标准规范
2017-09-01
现行
AASHTO M 279-14(2022)
Standard Specification for Metallic-Coated, Steel Woven Wire Fence Fabric [ASTM Designation: A116-11(2016)]
金属涂层钢丝编织栅栏织物的标准规范(ASTM名称:A 116-11)
现行
ASTM A974-97(2021)
Standard Specification for Welded Wire Fabric Gabions and Gabion Mattresses (Metallic-Coated or Polyvinyl Chloride (PVC) Coated)
焊接钢丝网石笼和石笼垫(金属涂层或聚氯乙烯(PVC)涂层)的标准规范
2021-09-01