1.1 本规范规定了三种尺寸的砜塑料插入配件和铜压接环的要求( 1. / 2. , 3. / 4. 和1）符合规范要求的交联聚乙烯（PEX）管材 第876页 或 F3253英镑 ，以及符合规范要求的高温聚乙烯（PE-RT）管材 第2623页 这些配件适用于100 psi（690 kPa）的冷水和热水分配系统，温度高达180 华氏度（82 °C）。包括材料、模制件财产、性能、工艺、尺寸和配件和环上使用的标记的要求。 1.2 单位- 以英寸磅为单位的数值应视为标准。括号中给出的值是国际单位制的数学转换，仅供参考，不被视为标准。 1.3 以下是本规范附录的索引。 GO/NO-GO压接仪表 附录X1 1.4 以下注意事项仅适用于试验方法部分，第节 11 和 12 ，符合本规范。 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification establishes requirements for sulfone plastic insert fittings and copper crimp rings for three sizes ( 1 / 2 , 3 / 4 , and 1) of cross-linked polyethylene (PEX) tubing that meet the requirements for Specification F876 or F3253 , and polyethylene of raised temperature (PE-RT) tubing that meet the requirements of Specification F2623 . These fittings are intended for use in 100 psi (690 kPa) cold- and hot-water distribution systems operating at temperatures up to and including 180 °F (82 °C). Included are the requirements for material, molded part properties, performance, workmanship, dimensions, and markings to be used on the fittings and rings. 1.2 Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 The following is an index of the appendix in this specification. GO/NO-GO Crimp Gauges Appendix X1 1.4 The following precautionary caveat pertains only to the test method portions, Sections 11 and 12 , of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.