1.1 本规范 2. 涵盖两个等级的锆和锆合金无缝管和焊接管。 1.2 除非使用单个单元，例如腐蚀质量增量，单位为mg/dm 2. ，以英寸磅或国际单位制表示的数值应单独视为标准。在文本中，国际单位制单位显示在括号中。每个系统中规定的数值并不完全相等；因此，每个系统应独立于其他系统使用。将两个系统的值组合在一起可能会导致不符合规范。 1.3 以下注意事项仅适用于本规范的试验方法部分: 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification 2 covers two grades of zirconium and zirconium alloy seamless and welded tubes. 1.2 Unless a single unit is used, for example corrosion mass gain in mg/dm 2 , the values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.3 The following precautionary caveat pertains only to the test methods portion of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.