1.1 本规程旨在用于制作环形试样，用于评估复合结构中钢筋和树脂的机械性能。本规程概述了试样制备的步骤，包括适用的最终试样加工。包括三种最终的环配置。 1.2 以国际单位制或英寸磅单位表示的数值应单独视为标准值。每个系统中规定的值可能不完全相等；因此，每个系统应独立使用。将两个系统的值合并可能导致不符合标准。 1.3 本标准并不旨在解决与其使用相关的所有安全问题（如有）。 本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 注1: 没有已知的ISO等同于此做法。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《国际标准、指南和建议制定原则决定》中确立的国际公认标准化原则制定的。 =====意义和用途====== 4.1 本规程为制作用作试样的玻璃纤维/热固性树脂环样品提供了统一的程序。如此制备的试样可用于试验方法 290页 和 D2344/D2344米 .

1.1 This practice is intended for use in the fabrication of ring-type test specimens to be used in the evaluation of the mechanical properties of reinforcement and resins in a composite structure. The practice outlines the steps in the preparation of the test specimens, including the final specimen machining where applicable. Three final ring configurations are included. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this practice. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 This practice provides a uniform procedure for fabricating glass fiber/thermoset resin ring samples for use as test specimens. Specimens so prepared can be used in Test Methods D2290 and D2344/D2344M .