本标准描述了船载设备的振动测试程序，规定了振幅， 频率和耐久性要求。这些试验旨在确定设备的共振位置，并在这些频率（如有）下进行耐久性试验。试验的频率范围为4 Hz至50 Hz（往复式机械安装设备为100 Hz）。本标准适用于以下船舶设备:控制和仪表、导航和通信、桅杆安装设备、机械部件。对于特殊机械、设备和装置，如天线、大型机械项目和某些特殊设计，经相关方批准，可能有必要偏离本标准。根据本标准可以测试的设备和机械的最大尺寸和质量无法定义，因为可用振动的能力- 测试机器各不相同。此外，一个给定的设备或机械，虽然太大，无法在振动试验机上容纳，但可以被分成足够小的部件进行试验。控制和仪表设备虽然通常连接在较大的机械上，但都是以这种方式进行测试的。将设备分为组件进行振动测试必须得到买方或验收机构的批准。

This standard describes procedures for vibration testing of shipboard equipment, specifying amplitude, frequency, and endurance requirements.The tests are intended to locate resonances of the equipment and impose endurance tests at these frequencies, if any. The frequency range of the tests is 4 Hz to 50 Hz (100 Hz for reciprocating machinery-mounted equipment).This standard is applicable to the following shipboard equipment:control and instrumentation,navigation and communication,mast-mounted equipment,machinery components.For special machinery, equipment and installations such as antennae, large machinery items and certain unusual designs, it may be necessary to deviate from this standard, subject to approval by the parties concerned.The maximum size and mass of equipment and machinery that can be tested in accordance with this standard cannot be defined because the capacities of available vibration-testing machines vary. Furthermore, a given piece of equipment or machinery, although too large to be accommodated on a vibration-testing machine, may be separated into components that are small enough for testing. Control and instrumentation equipment, although often attached to larger pieces of machinery, are tested in this manner. Separating equipment into component parts for vibration testing must be approved by buyer or acceptance authority.