1.1 本规程旨在满足对安全处理和注入小（非散装）彩弹的基本程序信息的需求 2. 通常与彩弹标记一起使用的圆柱体，用于推进彩弹。本标准不涉及可能用于注入较小气瓶的供应气瓶的注入、储存和处理问题。 1.2 公司 2. 填充程序是为彩弹场或商店经营者或两者最常用的压力循环气瓶注入方法编写的。 1.3 这种做法不应与联邦、州、省或市的规范或法规相混淆；保险要求；或国家安全规范。 1.4 本规程并不旨在解决与安全处理和注入小型彩弹钢瓶相关的所有安全问题（如有）。 本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性，例如但不限于DOT、CGA和OSHA。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This practice is intended to satisfy the demand for information on the basic procedures for the safe handling and transfilling of small (not bulk) paintball CO 2 cylinders commonly used with a paintball marker for propulsion of a paintball. This standard does not address issues dealing with the transfilling, storage, and handling of supply cylinders that may be used in transfilling smaller cylinders. 1.2 The CO 2 fill procedures are written for the pressure cycling cylinder transfilling method most commonly used by paintball field or store operators, or both. 1.3 This practice should not be confused with federal, state, provincial, or municipal specifications or regulations; insurance requirements; or national safety codes. 1.4 This practice does not purport to address all of the safety problems, if any, associated with the safe handling and transfilling of small paintball cylinders. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations, such as and not limited to DOT, CGA, and OSHA, prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.