1.1 本试验方法包括测定电绝缘清漆应用于薄膜绝缘磁线的扭线圈时的粘合强度。使用特定类型的薄膜绝缘导线将显示薄膜涂层和清漆的组合值。 1.2 标准值以英寸-磅为单位。括号中给出的值仅供参考。 注1: 尽管本标准和IEC 61033的方法C在方法或细节上有所不同，但使用其中一种方法获得的数据在技术上是等效的。 1.3 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 第节给出了具体的预防说明 7. . 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 5.1 当在本试验方法中所述的条件下测量时，通过弯曲试验获得的值提供了与特定清漆与特定类型磁线结合的粘结强度有关的信息。

1.1 This test method covers the determination of the bond strength of an electrical insulating varnish when applied to a twisted coil of film-insulated magnet wire. The use of a particular type of film-insulated wire will show the values for that combination of film coating and varnish. 1.2 The values stated in inch-pound units are the standard. The values given in parentheses are for information only. Note 1: Although this standard and Method C of IEC 61033 differ in approach or detail, data obtained using either are technically equivalent. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. A specific precautionary statement is given in Section 7 . 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 Values obtained by flexural test provides information with regard to the bond strength of the particular varnish in combination with a particular type of magnet wire, when measured under conditions described in this test method.