1.1 各种金属被电沉积在不锈钢上，用于配色、冷镦、弹簧卷绕和拉丝操作期间的润滑、减少高温下的结垢、改善润湿性（如自来水笔）、改善热和导电性、防止磨损、珠宝装饰和防止表面生锈。 1.2 本规程旨在帮助电镀和精加工工程师解决不锈钢上电沉积金属的固有问题。 这不是一个标准化程序，而是在不锈钢上生产光滑粘附电镀层的指南。 1.3 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 Various metals are electrodeposited on stainless steel for color matching, lubrication during cold heading, spring-coiling and wire-drawing operations, reduction of scaling at high temperatures, improvement of wettability (as in fountain pens), improvement of heat and electrical conductance, prevention of galling, jewelry decoration, and prevention of superficial rusting. 1.2 This practice is presented as an aid to electroplaters and finishing engineers, confronted with problems inherent in the electrodeposition of metals on stainless steel. It is not a standardized procedure but a guide to the production of smooth adherent electrodeposits on stainless steel. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.