1.1这些试验方法包括用于评估拘留所和教养所滑动装置组件的正常操作性能和在攻击、烟雾和火灾条件下的性能特征的仪器、程序和验收条件。这些测试方法表明了设备在实际使用中的性能特征。未考虑安装和维护条件等变量。 1.2这些测试方法的目的是帮助确保拘留滑动装置的性能达到或高于最低可接受水平，以控制未经授权或安全区域的通行，限制囚犯，延迟和挫败越狱企图，抵制故意破坏行为。 然而，这些试验方法不涉及门结构。众所周知，为了满足这些试验方法的目的，门组件应符合试验方法F1450要求的性能水平。 1.3以英寸-磅为单位的数值应视为标准值。括号中给出的值仅供参考。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。

1.1 These test methods cover the apparatus, procedures, and acceptance conditions for evaluating the normal operational performance and the performance characteristics under assault, smoke, and fire conditions of sliding device assemblies in detention and correctional institutions. These test methods give an indication of the performance characteristics of devices in actual service. Such variables as installation and maintenance conditions are not considered. 1.2 It is the intent of these test methods to help ensure that detention sliding devices perform at or above minimum acceptable levels to control passage to unauthorized or secure areas, to confine inmates and to delay and frustrate escape attempts and resist vandalism. However, these test methods do not address door construction. It is recognized that in order to meet the intent of these test methods, door assemblies shall be compatible with the level of performance required by Test Methods F1450. 1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.