1.1 这种加速试验的试验方法是一种测定钢质管道涂层对粗磨料和水的浆料磨损的相对阻力的程序。该方法适用于所有类型的电绝缘管道涂层和胶带的测试，包括热塑性塑料、热固性材料和沥青材料。 1.2 管道涂层通常不会受到本文规定的磨损类型的影响。 1.3 可以对锌等金属保护涂层进行目视比较，但不符合本试验方法的电气要求。 1.4 以国际单位制单位表示的值至三位有效小数应视为标准。括号中给出的值仅供参考。 1.5 本标准并不旨在解决与其使用相关的所有安全问题（如有）。 本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。 ====意义和用途====== 5.1 本程序规定了比较管道涂层相对耐磨性的试验方法。 5.2 在研究新涂层系统或方法的开发和研究工作以及质量控制中，耐磨性可用于指定候选材料的最佳涂层厚度。

1.1 This test method of accelerated test is a procedure for determining the relative resistance of steel pipeline coatings to abrasion by a slurry of coarse abrasive and water. The method is intended to apply to the testing of all types of electrical insulating pipeline coatings and tapes, including thermoplastics, thermoset, and bituminous materials. 1.2 Pipeline coatings are not normally subjected to the type of abrasion herein specified. 1.3 Metallic protective coatings such as zinc may be compared visually, but do not meet the electrical requirements of this test method. 1.4 The values stated in SI units to three significant decimals are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 This procedure defines a test method for comparing the relative resistance of pipeline coatings to abrasion. 5.2 Abrasion resistance may be used to specify optimum coating thickness of candidate materials both in development and research work to study new coating systems or methods and in quality control.