IEC 60079-14:2013包含爆炸性环境中或与爆炸性环境相关的电气装置的设计、选择、安装和初始检查的具体要求。如果设备需要满足其他环境条件，例如防止进水和耐腐蚀，则可能需要额外的保护要求。本标准的要求仅适用于在IEC 60079-0规定的标准大气条件下使用设备。对于其他条件，可能需要采取额外的预防措施，并且设备应针对这些其他条件进行认证。例如，大多数易燃材料和许多通常被视为非易燃材料的材料- 易燃物在富氧条件下可能会剧烈燃烧。这些要求是对非危险区域安装要求的补充。本标准适用于所有电气设备，包括固定式、便携式、可移动式和个人式设备，以及永久性或临时性安装。本标准未考虑与浓度通常远低于爆炸下限的易燃气体、液体和粉尘相关的毒性风险。在人员可能接触到潜在有毒浓度易燃材料的位置，应采取适当的预防措施。此类预防措施不在本标准范围内。 第五版取消并取代2007年出版的第四版。本版为技术修订版。有关具体修订和附加注释的列表，请参阅本文件的前言。 关键词:爆炸性环境中电气装置的设计、选择、安装和初步检查要求

IEC 60079-14:2013 contains the specific requirements for the design, selection, erection and initial inspection of electrical installations in, or associated with, explosive atmospheres. Where the equipment is required to meet other environmental conditions, for example, protection against ingress of water and resistance to corrosion, additional protection requirements may be necessary. The requirements of this standard apply only to the use of equipment under standard atmospheric conditions as defined in IEC 60079-0. For other conditions, additional precautions may be necessary, and the equipment should be certified for these other conditions. For example, most flammable materials and many materials which are normally regarded as non-flammable might burn vigorously under conditions of oxygen enrichment. These requirements are in addition to the requirements for installations in non-hazardous areas. This standard applies to all electrical equipment including fixed, portable, transportable and personal, and installations, permanent or temporary. No account is taken in this Standard of the toxic risks that are associated with flammable gases, liquids and dusts in concentrations that are usually very much less than the lower explosive limit. In locations where personnel may be exposed to potentially toxic concentrations of flammable material, appropriate precautions should be taken. Such precautions are outside the scope of this Standard. This fifth edition cancels and replaces the fourth edition published in 2007. This edition constitutes a technical revision. Refer to the document's Foreward for a listing of the specific revisions and additional Notes. Key words: requirements for the design, selection, erection and initial inspection of electrical installations in explosive atmospheres