首页 馆藏资源 舆情信息 标准服务 科研活动 关于我们
现行 ASTM D3468/D3468M-99(2020)
到馆提醒
收藏跟踪
购买正版
Standard Specification for Liquid-Applied Neoprene and Chlorosulfonated Polyethylene Used in Roofing and Waterproofing 用于屋面和防水的液体氯丁橡胶和氯磺化聚乙烯的标准规范
发布日期: 2020-05-01
1.1 本规范涵盖适用于屋顶和防水的液体氯丁橡胶和氯磺化聚乙烯合成橡胶溶液。 1.2 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值可能不是精确的等效值;因此,每个系统应相互独立使用。将两个系统的值合并可能会导致不符合标准。 1.3 以下预防性警告仅适用于试验方法部分第节 9 ,本规范: 本标准并非旨在解决与其使用相关的所有安全问题(如有)。本标准的用户有责任在使用前制定适当的安全、健康和环境实践,并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒(TBT)委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。
1.1 This specification covers liquid-applied neoprene and chlorosulfonated polyethylene synthetic rubber solutions suitable for use in roofing and waterproofing. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3 The following precautionary caveat pertains only to the Test Methods portion, Section 9 , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
分类信息
关联关系
研制信息
归口单位: D08.09
相似标准/计划/法规
现行
ASTM D6083/D6083M-24
Standard Specification for Liquid-Applied Acrylic Coating Used in Roofing
屋面用液体丙烯酸涂料的标准规范
2024-01-01
现行
ASTM C1330-23
Standard Specification for Cylindrical Sealant Backing for Use with Cold Liquid-Applied Sealants
与冷液体应用密封剂一起使用的圆柱形密封剂背衬的标准规范
2023-05-01
现行
ASTM D6694/D6694M-15(2023)
Standard Specification for Liquid-Applied Silicone Coating Used in Spray Polyurethane Foam Roofing Systems
喷涂聚氨酯泡沫屋顶系统用液体涂敷硅涂层的标准规范
2023-01-01
现行
ASTM C957/C957M-17(2024)
Standard Specification for High-Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with Integral Wearing Surface
具有整体磨损表面的高固体含量、冷液体应用弹性防水膜的标准规范
2024-04-15
现行
ASTM D6947/D6947M-16(2023)
Standard Specification for Liquid Applied Moisture Cured Polyurethane Coating Used in Spray Polyurethane Foam Roofing System
用于喷涂聚氨酯泡沫屋顶系统的液体涂敷湿固化聚氨酯涂层的标准规范
2023-01-01
现行
ASTM C836/C836M-18(2022)
Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane for Use with Separate Wearing Course
与单独磨耗层一起使用的高固体含量冷液体应用弹性防水膜的标准规范
2022-01-01
现行
ASTM D8463/D8463M-23
Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric, Silyl-Terminated Polymer Based Waterproofing Membrane for Use with Separate Wearing Course
与单独磨耗层一起使用的高固体含量、冷液应用的硅烷基端接聚合物基弹性防水膜的标准规范
2023-10-01