本文件是ETSI制定的一套标准的一部分，旨在采用模块化结构，以 覆盖RE指令[6]范围内的所有无线电设备。模块化结构如ETSI所示 例201399[i.1]。利用给定的地球静止卫星确定用户地面站的参数，以保护地球 分配给该卫星的频谱被视为由卫星运营商或卫星负责 网络运营商。因此，ETSI中对交叉极化歧视的要求 TBR 043[i.3]未在本文件中复制，且频带内的互调限制为5850 GHz至 7075 GHz由系统设计确定，并符合卫星运营商规范。 选择这些要求是为了确保与其他无线电服务具有足够的兼容性。水平， 但是，不要涵盖可能发生在任何地点但发生概率较低的极端情况。 本文件可能不包括潜在干扰源正在产生 存在个别重复的瞬态现象或连续现象，例如，在 附近。在这种情况下，可能需要对干扰源或 受干扰的部分或两者。本文件不包含有关安装的任何要求、建议或信息 VSAT。与接收、处理和呈现所接收信息有关的室内机的所有部分，但 控制通道不在本文件的范围内。控制通道消息的语法在外部 本文件的范围。

The present document is part of a set of standards developed by ETSI and is designed to fit in a modular structure to cover all radio equipment within the scope of the RE Directive [6]. The modular structure is shown in ETSI EG 201 399 [i.1].The determination of the parameters of the user earth stations using a given geo-stationary satellite for the protection of the spectrum allocated to that satellite is considered to be under the responsibility of the satellite operator or the satellite network operators. For this reason the requirement on the cross polarization discrimination which was in ETSI TBR 043 [i.3] has not been copied in the present document and inter-modulation limits inside the band 5,850 GHz to 7,075 GHz are to be determined by system design and are subject to satellite operator specifications.The requirements have been selected to ensure an adequate level of compatibility with other radio services. The levels, however, do not cover extreme cases which may occur in any location but with a low probability of occurrence. The present document may not cover those cases where a potential source of interference which is producing individually repeated transient phenomena or a continuous phenomenon is present, e.g. a radar or broadcast site in the near vicinity. In such a case it may be necessary to use special protection applied to either the source of interference, or the interfered part or both.The present document does not contain any requirement, recommendation or information about the installation of the VSAT.All parts of the indoor unit related to reception, processing and presentation of the received information except the control channel are not within the scope of the present document. The syntax of the control channel messages is outside the scope of the present document.