IEC TS 61300-3-16:20 23是一项技术规范，涉及3.2中定义的逆变式电能供应设备（ESE）的逆变器产生的谐波（包括分组间谐波）电流的限制，但不包括储能。本文件中给出的限值适用于3.3（另见5.2.3）中定义的每相参考电流小于或等于75 A的逆变器，旨在连接到以下类型的公共低压交流配电系统: -单相、两线或三线；额定电压高达240 V -三相、三线或四线；标称电压高达690 V -50Hz或60Hz的标称频率。 本文件规定: a)设备的要求和排放限值； b)型式试验和模拟的方法。按照本文件进行的试验是对成套设备进行的型式试验。 主要吸收能源但能够作为次要功能向公共供应能源的设备不在本文件的范围内。 例子？电梯电机驱动在制动期间返回能量。 本文件提供了高达40次谐波（h40）范围内设备的限值和测试程序，即2 000 Hz或2 400 Hz，具体取决于线路频率。 注1？在本文件的未来版本中，可能会增加2 kHz至9 kHz范围内的频率限制。 注2？在本文档的未来版本中，可能会添加存储系统的限制和程序。

IEC TS 61300-3-16:2023 which is a technical specification, deals with the limits for harmonic (including grouped interharmonic) currents produced by the inverter of inverter-type electrical energy-supplying equipment (ESE) as defined in 3.2, but which does not include energy storage. The limits given in this document are applicable to inverters with a reference current as defined in 3.3 (see also 5.2.3) less than or equal to 75 A per phase, intended to be connected to public low-voltage AC distribution systems of the following types:
- single-phase, two or three wires; nominal voltage up to 240 V
- three-phase, three or four wires; nominal voltage up to 690 V
- nominal frequency of 50 Hz or 60 Hz.
This document specifies:
a) requirements and emission limits for equipment;
b) methods for type tests and simulations.
Tests in accordance with this document are type tests of complete pieces of equipment.
Equipment which mainly absorbs energy but which is capable of supplying energy to the public supply as a secondary function is out of the scope of this document.
EXAMPLE？An elevator motor drive returning energy during braking.
This document provides limits and testing procedures for equipment in the range up to harmonic order 40 (h40), i.e. 2 000 Hz or 2 400 Hz depending on line frequency.
NOTE 1？It is possible that limits for frequencies in the range from 2 kHz to 9 kHz will be added in a future edition of this document.
NOTE 2？It is possible that limits and procedures for storage systems will be added in a future edition of this document.