本规范规定了汽车微型灯泡保持装置的要求和测试程序，包括带整体连接器的楔形底座插座、直接接线楔形底座插座、电路板组件和相关接口。当出现以下情况时，测试应遵循附录E流程图中所示的顺序:对现有设备进行的可能影响测试结果的–新设计–设计、材料或工艺变更。附录F中所示的测试顺序应每年进行一次。（注:根据批准的控制计划以较短的时间间隔收集的生产过程控制数据，经客户负责工程师和采购代表批准后，可以替换。）

This specification establishes the requirements and test procedures for automotive miniature bulb retention devices, including wedge base sockets with integral connector, direct wire wedge base sockets, circuit plate assemblies, and associated interfaces. Tests shall follow the sequence shown in the flow charts in Appendix E whenever the following occurs: • New design • Design, material or process change made to an existing device, which could affect the outcome of the test. The test sequence shown in Appendix F shall be run annually. (Note: Production process control data collected at a shorter interval per an approved control plan, may be substituted if approved by customer’s responsible engineer and purchasing representative.)