本规范规定了汽车微型灯泡保持装置的要求和试验程序，包括带整体连接器的楔形底座插座、直丝楔形底座插座、带整体连接器的卡口底座插座、直丝卡口底座插座、带电路板组件的楔形底座和卡口底座插座以及相关接口。当出现以下情况时，应按照附录E和F中流程图所示的顺序进行试验:新设计。对现有设备进行的设计、材料或工艺变更，可能会影响测试结果。 附录G中所示的试验顺序应每年进行一次。注:根据批准的控制计划，以较短的时间间隔收集的生产过程控制数据，经客户负责工程师和采购代表批准后，可以替换。

This specification establishes the requirements and test procedures for automotive miniature bulb retention devices, including wedge base sockets with integral connectors, direct wire wedge base sockets, bayonet base sockets with integral connectors, direct wire bayonet base sockets, wedge base and bayonet base sockets with circuit plate assemblies, and associated interfaces.Tests shall follow the sequence shown in the flow charts in Appendices E and F whenever the following occurs:New design.Design, material, or process change made to an existing device, which could affect the outcome of the test.The test sequences shown in Appendix G shall be run annually.NOTE: Production process control data collected at a shorter interval, per an approved control plan, may be substituted if approved by customer¿¿¿s responsible engineer and purchasing representative.